Cloud-electronics CDR-1B Bedienungsanleitung PDF herunterladen (Seite 16)

CDR‑1 & CDR‑1F Installation Guide v2.016

Installer mode allows access to the following unit-specic settings:

• Backlight and contrast adjustment

• Inactivity time

• Zone assignment

• Set Engineer key

Each of the above settings can be accessed in turn by pressing the ZONE button.

A full description of Installer Mode can be found in the DCM-1/e Installation and

User Guide, Section 3 (Conguration).

To return the CDR to normal operation:

• Remove power from the CDR.

• Move jumper J1 from ON to OFF

• Reapply the power

• Ret the remote control to its mounting plate with the two M3 screws (CDR-1)

or to its back box/mounting hole with the front panel xing screws (CDR-1F).

User mode

The CDR’s normal operating state is User Mode, which permits selection of music

source, level adjustment, and Group enabling/disabling (if available).

User Mode is fully described in the DCM-1/e Installation and User Guide,

Section 3 (Conguration).

Engineer mode

The CDR can be used to adjust the EQ in a zone from within the zone itself by putting

it in Engineer Mode. Engineer Mode must rst be enabled from the DCM-1/e, and then

a “password” key code entered on the CDR. The default key is listed below. The key can

be changed in Installer Mode.

A full description of Engineer Mode, and how to enable it can be found in the

DCM-1/e Installation and User Guide, Section 3 (Conguration).

1 2 ... 11 12 13 14 15 16 17 18 19 20

Keine Kommentare

Cloud-electronics CDR-1B Bedienungsanleitung Seite 16