Cloud-electronics CDR-1B Bedienungsanleitung PDF herunterladen (Seite 10)

CDR‑1 & CDR‑1F Installation Guide v2.010

Connecting and mounting – CDR-1

The CDR-1 is designed for use with single-gang UK, US or Australian electrical back

boxes, using the mounting plate provided. It is also possible to mount it without a back

box directly onto a wall.

The mounting plate has several sets of xing holes to accommodate the different styles

of box. UK single-gang boxes are square, but note that if tting to a US or Australian

box, it should be tted with the long axis horizontal (‘landscape’ orientation), with the

screw holes to left and right.

1. Detach the mounting plate from the rear of the CDR-1 by removing the two

countersunk M3 screws. Retain the screws.

2. With back box: bring the CAT-5 cable(s) into the back box and pass through the

entry hole on the mounting plate. If a local external PSU is being used to power

the CDR-1, the DC feed from this should be fed through as well.

Without back box: simply pass the cables through the mounting plate entry

hole.

3. With back box: attach the mounting plate to the back box using the M3.5 screws

provided and the appropriate holes in the mounting plate (according to back box

type).

Without back box: x the mounting plate directly to the wall, using screws (not

supplied) of a length and type appropriate for the wall construction. Note that it

is important that only countersunk-headed screws are used, as a raised screw head

may foul the CDR-1’s internal PCB.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Keine Kommentare

Cloud-electronics CDR-1B Bedienungsanleitung Seite 10