Cloud-electronics CDR-1B Bedienungsanleitung PDF herunterladen (Seite 15)

CDR‑1 & CDR‑1F Installation Guide v2.0 15

Each CDR must be assigned to a zone; this will normally be the zone in which it is

physically located. As shipped from the factory, a CDR has no zone assigned, and when

powered for the rst time it will rst display the backlight/contrast adjust screen, and

then prompt for a zone assignment before continuing, as shown below:

Use the + and – keys to scroll to the zone required, unless Zone 1 is correct. Press the

ZONE button to accept the assignment (the display changes to the Set Key screen);

after a few seconds, the CDR will enter normal User Mode, with the zone assignment

conrmed.

If it is necessary to change the zone assignment at a later date for any reason, this can

be done by putting the CDR into Installer Mode (see below).

Installer mode

To put the CDR in Installer Mode:

• Remove the CDR from its back box or mounting position by removing the two M3

screws at the bottom of the housing in the case of the CDR-1, or by removing the

two front xing screws in the case of the CDR-1F. Retain the screws.

• Remove power from the CDR, either by powering the system down or removing

the POWER IN connector.

• Move jumper J1 from OFF to ON

• Reapply the power

Conguration

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Keine Kommentare

Cloud-electronics CDR-1B Bedienungsanleitung Seite 15