Cloud-electronics ME-1B Bedienungsanleitung PDF herunterladen (Seite 3)

ME-1 Series Installation Guide v2.0 3

PIN USE CAT-5 CORE

1 Left (cold) White + Orange

2 Left (hot) Orange

3 Sense White + Green

4 DC +ve Blue

5 0v White + Blue

6 DC -ve Green

7 Right (hot) White + Brown

8 Right (cold) Brown

SCN Screen Connector Shell

ME-1M (Media version)

The Cloud ME-1M is a 100 x 50 mm “Euro-module”, and is designed to clip into a mounting frame with this size cut-out (not

supplied). Suitable mounting frames are available in most European and other territories, to t local electrical back box dimensions.

Ensure that the back box has a depth of at least 35 mm. The module is secured in place by the six plastic clips (three top, three

bottom).

Wiring

The ME-1’s OUTPUT connector should be connected to one of the DCM1’s MICROPHONE INPUTs with screened Cat 5 cable

and shielded RJ45 plugs.

Connect to

Output socket

Screened

Cat 5 cable

MICROPHONE INPUTS

EXTENSION PORTS

DCM-1

Connect to an

unused Microphone Input

ME-1

OUTPUT

LINK

UK version illustrated

Note that all ME-1s have two RJ45 connectors, OUTPUT and LINK. On ME-1 and ME-1A versions, they are both mounted on the

lower PCB, with the OUTPUT connector on the right (looking at the module rear). On ME-1M versions, they are mounted on

separate PCBs; the OUTPUT connector is on the upper PCB.

IMPORTANT: Because the cables carry low-level audio, only screened Cat 5 should be used, the foil screen of the cable being

bonded to the metal screening can of the plugs. If an ME-1 is being mounted in close proximity to the DCM1, it may be possible to

use ready-made screened Cat 5 “patch” cables of an appropriate length. Otherwise, shielded RJ45 plugs should be crimped onto

the installed screened Cat 5 cable using the pinout shown below.

Mounting frame to suit UK-style

double-gang back box illustrated.

1 2 3 4

Keine Kommentare

Cloud-electronics ME-1B Bedienungsanleitung Seite 3